Experimental Physics and Industrial Control System
Hello, every one,
Recently We have purchased a 1747-DCM. But I am failed in the configuration.
some informations about our SLC system(only 1 SLC):
slot 0: SLC 5/03, slot 1: 1746-IB16, slot 2: 1746-OB16, slot 3: 1747-DCM
DIP switch 1
1 2 3 4 5 6 7 8
on on on on OFF OFF ON ON
SW2
1 2 3 4 5 6 7 8
ON ON ON ON OFF OFF ON ON
When I power up, the FAULT LED is always on.
The troubleshooting said that it caused by internal fault, we should "cycle power
to the I/O chassis containing the DCM or replace DCM if the red LED remains lit after powerup".
Are there something wrong with our DCM or I must write the program for the DCM at first?
Thanks,
-----------------------------------
SHEN Guobao
Shanghai Synchrotron Radiation Facility, SSRF
Phone: (86 21) 59553998-373
email: [email protected]
- Navigate by Date:
- Next:
a question about edm 黄松
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
<2003>
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Next:
a question about edm 黄松
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
<2003>
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024