Experimental Physics and Industrial Control System
> Garrett D. Rinehart wrote:
>
> > I'm trying to read all 32 channels of a Xycom 566 into a
> > waveform record, but I cannot get it to work.
> >
> > I have tested the board with AI records and it works fine.
> > When I remove the AI's and put in a WF, it just looks at me
> > stupidly.
>
Andrew wrote:
> If you look at the drvXy566.c file you'll see that ai and wf support
> effectively use two separate drivers, and I think they use different
> base addresses for their cards.
>
Andrew is correct. My "very old notes" indicate the following ...
Xycomm 566 Mode Register Address (A16) Memory Address (A24)
Single Ended 0x6000 0x000000
Differential 0x7000 0x040000
Differential Latched 0xE000 0x0C0000
Waveform Mode 0x9000 0x080000
These values, of course, can be modified using module_types.c
Ned
- Navigate by Date:
- Prev:
gdct313 - stepper-motor record problem. Bill Brown
- Next:
stepper-motor vs. motor record Janet Tvedt
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Xycom 566 waveforms Bob Dalesio
- Next:
gdct313 - stepper-motor record problem. Bill Brown
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024