EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  <20002001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  <20002001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: Kinetic Systems 2917/3922 CAMAC interface on PowerPC
From: Mark Rivers <[email protected]>
To: [email protected], [email protected]
Cc: [email protected]
Date: Wed, 19 Jul 2000 9:48:04 -0500
    Folks,

I am trying to use the CAMAC software which Eric Bjorklund and I wrote for
the Kinetic Systems 2917/3922 interface.  It works fine on the MV167/MV162
CPUs, but I am now trying to use it on the MV2700 (PPC).  I am running Tornado
2.0 (vxWorks 5.4) and EPICS R3.13.3.  The simple CAMAC I/O operations work
fine, but DMA and LAMs (interrupts) are not working.

Before I dive into this I thought I would check to see if anyone else has
already got this combination working?

                                   Thanks,

                                   Mark Rivers



Navigate by Date:
Prev: Driver for Acromag IP470? Peregrine M. McGehee
Next: EPICS on a PC Dennis M. Reichhold
Index: 1994  1995  1996  1997  1998  1999  <20002001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: Driver for Acromag IP470? Peregrine M. McGehee
Next: RE: Kinetic Systems 2917/3922 CAMAC interface on PowerPC Mark Rivers
Index: 1994  1995  1996  1997  1998  1999  <20002001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024