Experimental Physics and Industrial Control System
New releases of the Message Passing Facility and the serial support for MPF are
now available.The changes are:
MPF Release 1-6
The config files have been changed to use the base 3.13.3 makeBaseApp rules.
This method also works for earlier release ofbase.
Stack Overflow may occur for PowerPC. This problem was fixed by changing the
stack size in the calls to taskSpawn in the following files: RMRClient.cc,
RMRServer.cc, andTcp.cc.
DevMpf previously issued an error message and returned without calling startIO
if PACT is true and no replyMessage is present. This check is no longer made.
This allows the creation of device support that has to process several messages
before a record completes processing.
mpfSerial Release 1-2
The interrupt routine was modified so that it works correctly when the IP
modules uses separate interrupts for read and write.
The config files were changed to use the base 3.13.3 rules. It now builds
properly for 3.13.3 as well as previous releases of base.
Doc and tar files are available at:
http://www.aps.anl.gov/asd/people/mrk/epics/modules/bus/mpf/
- Navigate by Date:
- Prev:
Re: intConnect vs ipmIntConnect vs devConnectInterrupt Bernd Schoeneburg
- Next:
Re: Let's use the STL! [Was: about the abstractData.h] Bob Dalesio
- Index:
1994
1995
1996
1997
1998
1999
<2000>
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
address change for Phase Three Logic Chong Lee
- Next:
Let's use the STL! [Was: about the abstractData.h] Benjamin Franksen
- Index:
1994
1995
1996
1997
1998
1999
<2000>
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024