EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  <20012002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  <20012002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: et_wish for NT
From: Brian Tieman <[email protected]>
To: tech-talk <[email protected]>
Date: Mon, 15 Jan 2001 13:47:41 -0600
Hi all,

We have some users comming in this weekend who would like to use a
tck/tk program to control an experiment.  The tck/tk program must run on
WinNT because it's controlling a motor controller through an NT device
driver.  This user would like to sync this tcl program with several
other motors and a CCD camera system all of which are controllable
through Epics CA.

I know et_wish for unix has been around for a long time, but has anyone
tried building and running it on WinNT?  If so, is it possible to get a
pre-built binary somewhere?

Brian Tieman
Argonne National Laboratory



Replies:
Re: et_wish for NT Bernhard Kuner

Navigate by Date:
Prev: Re: device support for IK340 Andrew Johnson
Next: Re: device support for IK340 Tim Mooney
Index: 1994  1995  1996  1997  1998  1999  2000  <20012002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: Re: device support for IK340 Tim Mooney
Next: Re: et_wish for NT Bernhard Kuner
Index: 1994  1995  1996  1997  1998  1999  2000  <20012002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024