EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  <2007>  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  <2007>  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025 
<== Date ==> <== Thread ==>
Subject: Re: MVME6100 or 7100
From: "Oleg Makarov" <[email protected]>
To: "Matt Rippa" <[email protected]>, "EPICS tech-talk" <[email protected]>
Date: Wed, 28 Nov 2007 11:01:32 -0600 
GM / CA CAT at APS uses the MVME6100 on VxWorks 5.5.1/Tornado 2.2.1
Yes, I would recommend these!

Regards,
Oleg Makarov

----- Original Message ----- From: "Matt Rippa" <[email protected]>
To: "EPICS tech-talk" <[email protected]>
Sent: Wednesday, November 28, 2007 1:36 AM
Subject: MVME6100 or 7100


Hi All -

Are any sites using the MVME6100 on VxWorks 5.5.2/Tornado 2.2.1? If so, would you recommend these?

Has anyone considered the new MVME7100 board? I'm not sure on the state of the BSP.

Thanks,
-Matt

Replies:
checking the content of the waveform record Vladimir Sirotenko
References:
MVME6100 or 7100 Matt Rippa
Navigate by Date:
Prev: Re: JCA using problem J. Lewis Muir
Next: Re: Problem installing SDDS on OS X 10.5.1 Bertrand H.J. Biritz
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  <2007>  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025 
Navigate by Thread:
Prev: Re: MVME6100 or 7100 Till Straumann
Next: checking the content of the waveform record Vladimir Sirotenko
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  <2007>  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  2025