EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  <20082009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  <20082009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: several state sets in one stt file
From: Emmanuel Mayssat <[email protected]>
To: epics <[email protected]>
Date: Fri, 22 Feb 2008 17:29:40 -0800
Hello,

I am trying to start a sequencer program with several/independent state
sets. As it turns out the command seqShow reports that 2 threads are
running. But my second thread doesn't appear to be running. For example
seqLog messages do not appear anywhere(console or log file), my PV are
not updated, etc.

Is it possible to have several ss entries in one stt file?
Is there a trick to start/stop a specific state set?

PS: seq-2.0.11

Regards,
--
Emmanuel



Replies:
Re: several state sets in one stt file Matthieu Bec

Navigate by Date:
Prev: Re: TTL output with soft IOC on Linux Robert Horrox
Next: Re: several state sets in one stt file Matthieu Bec
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  <20082009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: Re: Problem with soft motor record Shepherd, EL (Emma)
Next: Re: several state sets in one stt file Matthieu Bec
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  <20082009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024