| 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 <2009> 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 <2009> 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025 |
| <== Date ==> | <== Thread ==> |
|---|
| Subject: | Re: driver support initiialization |
| From: | Matthieu Bec <[email protected]> |
| To: | Patrick Thomas <[email protected]> |
| Cc: | [email protected] |
| Date: | Wed, 22 Jul 2009 00:13:44 -0400 |
Hi Patrick,we use a similar technique in the VME world when there's need to pass parameters to drivers, that could be a base address set by h/w jumpers.
Look in the application developers guide for epicsExportRegistrar, iocshFuncDef, iocshArg and the like - that will allow your st.cmd invoke a C routine with user set params from your script.
Matthieu On 07/21/09 23:51, Patrick Thomas wrote:
Hi, I have created a device driver to interface with a serial to ethernet adpater, and I was just wondering if it is possible to send the IP address and port to the driver at initialization, say through an entry in the st.cmd file? Thank you, Patrick
-- Matthieu Bec Gemini Observatory Tel: +56 51 205785 c/o AURA, Casilla 603 Fax: +56 51 205650 La Serena, Chile