EPICS Re: copying output of Linux ioc to file

Experimental Physics and Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 <2010> 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 <2010> 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025
<== Date ==>		<== Thread ==>

Subject:	Re: copying output of Linux ioc to file
From:	Ralph Lange <[email protected]>
To:	Patrick Thomas <[email protected]>
Cc:	EPICS Tech Talk <[email protected]>
Date:	Thu, 22 Jul 2010 14:08:38 -0400

I would recommend running your IOC in procServ, which - among a large number of other things - allows you to log your IOC's output into a file.

procServ is available on SourceForge - it is also part of the Debian distribution.

Good luck!
Ralph

On 22.07.2010 13:55, Patrick Thomas wrote:

Hi,

I was wondering if there was a way to tee the output of a Linux ioc to a file? I have tried piping to the tee command, but this causes the output to 'freeze up' after a few seconds. Thank you for your time,

-Patrick

References:: copying output of Linux ioc to file Patrick Thomas

Navigate by Date:: Prev: copying output of Linux ioc to file Patrick Thomas; Next: EDM: subclassing ProcessVariable to support custom DAQ Carl Schumann; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 <2010> 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025
Navigate by Thread:: Prev: copying output of Linux ioc to file Patrick Thomas; Next: Re: copying output of Linux ioc to file emmanuel_mayssat; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 <2010> 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025