EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <20132014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <20132014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: edm run crashing, it displays "Segmentation fault (core dumped)"
From: Lai Longwei <[email protected]>
To: [email protected]
Date: Mon, 20 May 2013 23:21:53 +0800
Hello everyone,
i have just built my edm successfully, i can open edm, but when i draw any components on a new file,
it crashed and displayed Segmentation fault (core dumped).
the edm is 1-12-85. please give me some advise.
thanks very much


Replies:
Re: edm run crashing, it displays "Segmentation fault (core dumped)" Adam Bark

Navigate by Date:
Prev: CSS BEAST: how to report to an operator non alarm messages ? Capobianco Roberto
Next: EPID soft ioc slow feedback Miroslav Mihaylov
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <20132014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: CSS BEAST: how to report to an operator non alarm messages ? Capobianco Roberto
Next: Re: edm run crashing, it displays "Segmentation fault (core dumped)" Adam Bark
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <20132014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024