I would suggest using 3.14.12.4 and see if you still have a problem.
________________________________
From: Vikram Bhagat [
[email protected]]
Sent: Wednesday, June 04, 2014 3:14 PM
To: Mark Rivers; epics talk
Subject: Re: sequencer
installation
Dear Mark
There nothing special to use EPICS3.15, i am installing in my system so just took latest.
Vikram
On Wednesday, June 4, 2014 10:09 PM, Mark Rivers <
[email protected]> wrote:
You are using EPICS 3.15. Do you have a reason for using that? It is still not ready for production systems. Should you be using 3.14.12.4 instead?
Mark
________________________________
From:
[email protected]<mailto:
[email protected]> [
[email protected]<mailto:
[email protected]>] on behalf of Vikram Bhagat [
[email protected]<mailto:
[email protected]>]
Sent: Wednesday, June 04, 2014 3:02 PM
To: epics talk
Subject: sequencer installation
Hello,
I am trying to install sequencer but could not build
Below is the log an anyone guide me what is wrong with installation.
[
root@sarva-PC<mailto:
root@sarva-PC> sncseq]# make
make -C ./configure install
make[1]: Entering directory `/opt/epics/modules/sncseq/configure'
make -C O.linux-x86_64 -f ../Makefile TOP=../.. T_A=linux-x86_64 install
make[2]: Entering directory `/opt/epics/modules/sncseq/configure/O.linux-x86_64'
perl -CSD /opt/epics/base/bin/linux-x86_64/convertRelease.pl checkRelease
make[2]: Leaving directory `/opt/epics/modules/sncseq/configure/O.linux-x86_64'
make[1]: Leaving directory `/opt/epics/modules/sncseq/configure'
make -C ./src install
make[1]: Entering directory `/opt/epics/modules/sncseq/src'
make -C ./pv install
make[2]: Entering directory `/opt/epics/modules/sncseq/src/pv'
make -C O.linux-x86_64 -f ../Makefile TOP=../../.. T_A=linux-x86_64 install
make[3]: Entering directory `/opt/epics/modules/sncseq/src/pv/O.linux-x86_64'
make[3]: *** No rule to make target `/opt/epics/base-3.15.0.1/include/shareLib.h', needed by `pvNew.o'. Stop.
make[3]: Leaving directory `/opt/epics/modules/sncseq/src/pv/O.linux-x86_64'
make[2]: *** [install.linux-x86_64] Error 2
make[2]: Leaving directory `/opt/epics/modules/sncseq/src/pv'
make[1]: *** [pv.install] Error 2
make[1]: Leaving directory `/opt/epics/modules/sncseq/src'
make: ***
[src.install] Error 2
[
root@sarva-PC<mailto:
root@sarva-PC> sncseq]#
I set
EPICS_BASE=/opt/epics/base
in configure/RELEASE
Thanks
Vikram