RE: Phoebus alarm does not honor filter

["Zhang, Tong via Tech-talk" <tech-talk at aps.anl.gov>]

Hi Kay,

 

In the example you pointed out, where is the alarm configuration for PV ‘test_alarm’? I cannot see this information.

For the case I reported, the alarm PV is defined as an unlatched alarm, with 2 second delay. I’m not sure if such configuration may has anything to do with what had observed.

 

Thanks,

Tong

From: Kay Kasemir <kasemirk at ornl.gov>
Sent: Wednesday, June 22, 2022 12:30
To: Zhang, Tong <ZhangT at frib.msu.edu>; tech-talk at aps.anl.gov
Cc: Ashwarya, Tanvi <ashwarya at frib.msu.edu>
Subject: Re: Phoebus alarm does not honor filter

 

[EXTERNAL] This email originated from outside of FRIB

Hi Tong,

 

>..we're using the default Phoebus alarm server configuration (my understand is org.phoebus.pv.ca/monitor_mask=VALUE).

> I was trying to export the full configurations from Phoebus to confirm the monitor_mask value, but it seems it only print out the ones that maintained in /etc/phoebus_settings.ini.

 

If you don't see org.phoebus.pv.ca/monitor_mask in the preferences, it's using the default, which is VALUE.

I agree that it's unfortunate that you can't see all available settings in the Help, About, .. preference listing.

Way back when we started phoebus I had suggested a way of using the java preferences in a way to give us all settings, no matter if they're at the default or changed, https://github.com/ControlSystemStudio/phoebus/issues/4, but we ended up doing it such that the running instance can only list changes, for a complete listing you have to go to the online help.

 

> Can you offer any approach for further investigation?

 

Try to come up with a reproducible example.

I've described one based on the demo.db and opi that are included in the alarm examples, and that looks fine when I run that here.

See if it works for you.

 

-Kay

 

 

 

---
Well, I can't reproduce this.

Under https://github.com/ControlSystemStudio/phoebus/tree/master/app/alarm/examples, there's a demo.db and associated display.

I'm running a softIoc with that demo.db, add the test_alarm PV with enabling filter "test_enable>0" to the alarm tree, and then use the demo.bob display for the following:


1) Set test_alarm = 10, it shows up as MAJOR alarm in alarm table and tree
2) Set test_enable to 0. test_alarm is shown in gray with "(disabled)" in alarm tree, and not at all in alarm table
3) Set test_enable back to 1, and test_alarm shows back up as it looked in step 1