1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 <2024> | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 <2024> |
<== Date ==> | <== Thread ==> |
---|
Subject: | Galil advice for servo motors |
From: | Mark Rivers via Tech-talk <tech-talk at aps.anl.gov> |
To: | "tech-talk at aps.anl.gov" <tech-talk at aps.anl.gov> |
Date: | Wed, 17 Jan 2024 18:53:59 +0000 |
Folks, I have been using the Galil DMC-4183 controllers for stepper motors, both with pulse/direction outputs and on-board amplifiers. I now am setting up my first servo system with on-board amplifiers and quadrature encoders. I have a question about the best way to configure and save the PID parameters. Do people generally using the motor record to configure KP, KI,
and KD, or do you use the Galil GDK to configure those and then just save in the non-volatile memory on the controller? I did not find any discussion of this in the EPICS Galil documentation. Thanks, Mark |