Data acquisition Pico 2406B

[王鹏鹏 via Tech-talk <tech-talk at aps.anl.gov>]

-----原始邮件-----
发件人:"王鹏鹏" <wangpengpeng at impcas.ac.cn>
发送时间:2024-04-02 17:16:01 (星期二)
收件人: "Loeher, Bastian Dr." <B.Loeher at gsi.de>
抄送:
主题: Re: Re: Re:

Dear Bastian, I will send to EPICS tech talk mailing list quickly!

-----原始邮件-----
发件人:"Loeher, Bastian Dr." <B.Loeher at gsi.de>
发送时间:2024-04-02 17:12:34 (星期二)
收件人: "王鹏鹏" <wangpengpeng at impcas.ac.cn>
抄送:
主题: Re: Re:

Hi,

I'm very happy I could help you.

Perhaps you could also send this conversation to the EPICS tech talk mailing list so that others can profit as well?

Thanks

Bastian

Am 02.04.2024 09:52 schrieb 王鹏鹏 <wangpengpeng at impcas.ac.cn>:

Dear Bastian, I have successfully gotten the following acquisition according to your suggestions, thank you very much!!!

-----原始邮件-----
发件人:"Loeher, Bastian Dr." <B.Loeher at gsi.de>
发送时间:2024-04-02 14:32:33 (星期二)
收件人: "王鹏鹏" <wangpengpeng at impcas.ac.cn>
抄送:
主题: Re:

Dear Wang,

Did you install the vendor drivers for your scope?

Then, first thing after starting the IOC you have to connect to the scope. That can be done using the connect button in the GUI (only MEDM, sadly).

Cheers

Bastian

Am 02.04.2024 07:46 schrieb 王鹏鹏 <wangpengpeng at impcas.ac.cn>:

Hello Loeher, Bastian. I have a pico 2406B and want to integrate into EPICS. From epics tech talk found your pico_2000 in r3b_public / epics / pico_2000 · GitLab (gsi.de).

I have compiled it successfully in Ubuntu20.04. But I don't know how to set the right st.cmd.  When I set lsusb in console,  showed 

When i started pico_2000 directly,  showed not connected. I knowed how to set serial param using Asyn, but I don't know how to set USB device using Asyn. 

Any information you can provide is highly appreciated.

 Thanks a lot!