EPICS 3.14 support for Acromag digital

This page is the home of Acromag digital support. This consists of the following components :


These components previously resided in epics/base.

Hardware Supported

The module can drive the following types of hardware: Acromag 9940

VME Configuration

Since module_types.h is not support by EPICS 3.14, a config command is provided.

    devAvme9440Config(ncards, base, vector)
    ncards - number of modules. The default is 0.
    base - the VME address for the first card. The default is 0.
    vector - The interrupt vector for the first card. the default is 0.

Where to Find it

You can download the software by anonymous ftp from the links in the table below:

Module Version EPICS Release Filename Documentation Release Notes
R1-3 3.14.5 acromag1-3.tar.gz None None

Installation and Building

After obtaining a copy of the distribution, it must be installed and built for use at your site. These steps only need to be performed once for the site (unless versions of the module running under different releases of EPICS and/or the other required modules are needed).

Application Builds

In order to use the support in an application do the following: