--- Begin Message ---
Epics users:
Is there a way to set parity (none, even, odd) on a 162
serial port running vxworks 5.2? I see how you can set
just about everything else using "ioctl" but not parity.
I have a power supply that requires "even parity".
I know that there is an option (OPT_7_BIT) to strip the parity bit
on incoming data but no way of transmitting with even parity.
Also, has anyone written any software to communicate to
General Dynamics DC Power Supply
Model Number PD42-04000103-GKLX-PY57
We received this supply from the SSC and it has limited
documentation and no test software.
Thanks in Advance
--
______________________________________________________________________
| Scott Higgins * Telephone: |
| Machine Control Center, MS 85A * (757) 269 7411 (Work) |
| Thomas Jefferson National * (757) 680 7411 (Pager) |
| Accelerator Facility * (757) 269 7049 (Fax) |
| Newport News, Virginia 23606 * E-mail: [email protected] |
|______________________________________________________________________|
--- End Message ---
