EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  <19961997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  <19961997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: Help w/PulseTrain and PulseCounter using Mizar 8310 board
From: Tien Doan <[email protected]>
To: [email protected]
Date: Tue, 12 Nov 1996 19:17:06 -0500 (EST)


I'm trying to use the Mizar 8310 board for pulse width modulation and for 
tracking a frequency-modulated signal.  The device drivers I'm using are
the ones that came with EPICS r3.11.4.  My question are:

1.  the 8310 has 24 frequency output modes.  How do I put the board into 
the different frequency generation modes ?  is there a field in the 
PulseTrain block that would allow me to do this ?

2.  how do I use the pulseCounter block to track the FM signal ?  Do I
need to call the pulseCounter block every X sec, read the counter, 
then reset and restart the counter ?

thank you

Tien Doan



Replies:
Re: Help w/PulseTrain and PulseCounter using Mizar 8310 board Marty Kraimer

Navigate by Date:
Prev: A new subroutine record Andy Foster
Next: Re: RS232 Configuration Question on MVME162 John R. Winans
Index: 1994  1995  <19961997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: A new subroutine record Andy Foster
Next: Re: Help w/PulseTrain and PulseCounter using Mizar 8310 board Marty Kraimer
Index: 1994  1995  <19961997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024