Experimental Physics and Industrial Control System
Is there anyone who can help with this. We aren't using these devices
here.
Rozelle
----- Begin Included Message -----
>From [email protected] Mon Jan 19 07:17 MST 1998
Date: Mon, 19 Jan 1998 22:20:06 +0800
X-Mailer: Mozilla 4.01 [en] (Win95; I)
MIME-Version: 1.0
To: Rozelle Wright <[email protected]>
Subject: about GPIB interface
X-Priority: 3 (Normal)
References: <[email protected]>
Content-Transfer-Encoding: 7bit
X-Lines: 17
Hi Rozelle,
Since I have built the EPICS and run a simple example, of course with
your help, I decide to setup a test system with hardware. Because the
VME crate and IP modules we ordered have not arrive yet, I borrowed some
PC-based hardware, a HP82340 HP-IB interface card, a HP 8656B 0.1-990MHz
Signal Generator and a HP 54503A 500 MHz Digitizing Oscilloscope. I
don't know if the exist device support modules and/or drivers support
these hardwares. Also, I am not very clear what I must do in order to
setup this test system. Can you give or recommend me a example for
reference?
Thanks in advance!
Yours,
Li Jingyi
----- End Included Message -----
- Replies:
- Re: about GPIB interface Benjamin Franksen
- Navigate by Date:
- Prev:
Re: CAC running out of sockets Ralph Lange
- Next:
new record support Jeffrey Mcdonald
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Standalone Motor Controller/Driver Ned Arnold
- Next:
Re: about GPIB interface Benjamin Franksen
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024