Experimental Physics and Industrial Control System
Garrett,
>Is there a debug I can invoke to see what
>the 2992 is reading? I know the data is good as of the CAMAC
>backplane. After that, how can I tell what it is?
There is a "bcnaf" function included in the util directory. This should allow
you to issue CAMAC commands from the vxWorks shell and see the raw data that
comes back through the ht2992.
If I were to make a wild guess, I would suspect something screwy is going on
with the range specifications. Are you using the generic device support, or
one of your own? What does the CAMAC address specification in the INP field of
the record look like?
==============================================================================
Eric Bjorklund Voice: 505-667-6031
Los Alamos National Laboratory Email: [email protected]
AOT-6 MS H820
PO Box 1663
Los Alamos, NM 87545
==============================================================================
- Navigate by Date:
- Prev:
CAMAC problems Garrett D. Rinehart
- Next:
record linking question john sinclair
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
CAMAC problems Garrett D. Rinehart
- Next:
RE: CAMAC problems Garrett D. Rinehart
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024