EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  <20032004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  <20032004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: ACU-RITE Linear Encoder with OMS VME58-4E Problem
From: "Porter, Rodney R." <[email protected]>
To: <[email protected]>
Date: Thu, 21 Aug 2003 17:49:36 -0500

I am trying to interface an ACU-RITE Linear Encoder through the Step-Pak Motor Rack and the BCDA-005 Transition Module to the OMS VME58-4E Motor Controller.  Known concerns:  Unipolar signals so installed appropriate jumpers, No index signal (no signal attached), 5V power from the VME crate.  The encoder works for small moves, but at some points it “jumps’ to some unrelated position.  Has anyone seen this behavior, used this or a similar linear encoder, or have any ideas of the cause. 

 

Rodney Porter

Scientific Associate - Data Acquisition

Intense Pulsed Neutron Source Division

Argonne National Laboratory

 


Navigate by Date:
Prev: RE: problem loading iocCore (R3.13.9) Jeff Hill
Next: Channel Access Errors Gary P Carr
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  <20032004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: RE: problem loading iocCore (R3.13.9) Jeff Hill
Next: Channel Access Errors Gary P Carr
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  <20032004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024