1994 1995 1996 1997 1998 1999 2000 2001 2002 <2003> 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 <2003> 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Re: Command "seq" not found when running example ioc application |
From: | Marty Kraimer <[email protected]> |
To: | Andy Foster <[email protected]>, [email protected] |
Date: | Mon, 27 Oct 2003 07:35:46 -0600 |
Hi Marty, Steven,
The only small change I had to make to these instructions was that I had to add:
registrar(sncExampleRegistrar)
to myexampleApp/src/myExampleInclude.dbd rather than remove the comment character as this line was not in the file.
I think this is listed in "Known Problems" on the R3.14.4 web page.
Cheers,
Andy
On Mon, 27 Oct 2003, Marty Kraimer wrote:
[email protected] wrote:
I'm hoping someone can help me with what is probably a very simple problem.
We have completely reinstalled epics base (14.4.3 and 14.3.4) and the sequencer (2.0.7) onto a clean Red Hat Linux 9.0 environment and are trying to get the example application described in Getting Started in the IOC Developer's Guide up and going. We have followed the installation instructions to the letter in order to build and run EPICS, the Sequencer and the sncExample.st application.
When we run the example using the supplied st.cmd file, it all loads into the iocsh correctly until it gets to the command:
seq sncExample,"user=username"
At this point, we get the error:
st.cmd -- Line 28 -- Command seq not found
Everything appears to have built OK and when we run the demo example that comes with the sequencer, it executes correctly, including correctly starting up the sequencer. I presume from this that EPICS and the sequencer have built OK.
We are using gmake version 3.79.1 and have tried 3.80.0 as well, with no luck.
Can anyone out there tell me why the seq command is not found when I run this application?
Steve Banks Australian Synchrotron Project Department of Infrastructure Level 18, 80 Collins Street Melbourne VIC 3000 tel: +613 9655 6303 fax: +613 9655 8666 web: www.synchrotron.vic.gov.au
Are you sure you followed the instructions to edit the Makefile in myexampleApp/src as described in section 2.2.4 of the 02OCT2003 Application Developer's Guide?
When you build do you see the sequence program being built? For example on linux I see
converting ../sncExample.stt /home/phoebus/MRK/epics/modules/soft/seq/bin/linux-x86/snc ../sncExample.stt -o sncExample.c ....
Marty Kraimer
-------------------------------------------------------------------- Observatory Sciences Limited Email: [email protected] William James House Tel: 44 - (0)1223 - 508259 Cowley Road Fax: 44 - (0)1223 - 508258 Cambridge, CB4 0WX, UK http://www.observatorysciences.co.uk