Experimental Physics and Industrial Control System
I'm trying to initialise an analog output record
by putting a constant in the DOL field (see below).
But the VAL field gets set to zero rather than 100.
The record does process and outputs this zero.
I can work around this by Initialising from another record
using clsed loop mode but it does seem to be a bit of a cludge
(see commented out lines).
What am I doing wrong?
record(ao, "$(device):SETSIZE") {
field(DESC, "Pump Size")
field(DTYP, "ornlSerial")
field(OUT, "@digitel mpc size p=1 u=$(port) m=$(unit) p1=$(pump)")
field(PINI, "YES")
field(DOL, "100.0")
# field(DOL, "$(device):INITSIZE")
# field(OMSL, "closed_loop")
field(EGU, "l/s")
field(DRVL, "0.0")
field(DRVH, "1200.0")
field(LOPR, "0.0")
field(HOPR, "1200.0")
field(PREC, "0")
}
record(ai, "$(device):INITSIZE") {
field(VAL, "200.0")
}
Pete
---------------------------------------
mailto:[email protected]
phone:+44 (0)1925 603974
fax: +44 (0)1925 603124
CLRC
Daresbury Laboratory
Keckwick Lane
Warrington
WA4 4AD
UK
- Replies:
- RE: Initialising an ao record from a constant DOL Kim, Kukhee
- RE: Initialising an ao record from a constant DOL Kim, Kukhee
- Navigate by Date:
- Prev:
Base R3.13.10 now available Andrew Johnson
- Next:
VDCT build 1249 available John Maclean
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
<2004>
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Base R3.13.10 now available Andrew Johnson
- Next:
RE: Initialising an ao record from a constant DOL Kim, Kukhee
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
<2004>
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024