Experimental Physics and Industrial Control System
On Thu, 27 May 2004, Deb Kerstiens wrote:
> Anyone out there using Power 10 power supplies? If so, how did you
> interface them? We're looking at an RS-232 server made by Quatech.
We had a large number of Power 10's in use, but have phased out most of
them in the last few years. We just used an external 16-bit DAC for
control and a SAM for readback, though the performance of the PS wasn't at
the 16-bit level. Our experience with the Power 10's was good
reliablility, but the performance wasn't up to our requirements,
particularly 60 Hz AC ripple.
--
Steve Hartman
[email protected] || 919-660-2650
Duke Free Electron Laser Laboratory
- References:
- EPICS indexed by the FSF/UNESCO Free Software Directory Jeff Hill
- Power Ten power supplies Deb Kerstiens
- Navigate by Date:
- Prev:
Re: Power Ten power supplies AL Hillman
- Next:
EtherIP & AB PLC's D Wetherholt
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
<2004>
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Power Ten power supplies AL Hillman
- Next:
MEDM crashes immediately under Linux J. Lewis Muir
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
<2004>
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024