1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | JCA problems-entry point in ca.dll not found |
From: | "daniel funken" <[email protected]> |
To: | <[email protected]> |
Date: | Wed, 9 Jun 2004 14:50:37 -0400 |
When i try to run the tutorial program shown http://www.aps.anl.gov/xfd/SoftDist/swBCDA/jca/2.1.2/tutorial.html
in the dos command prompt i get an error message
that:
The procedure entry point _ca_write_access@4 could
not be located in the dynamic link library ca.dll.
I did add ca.dll, jca.dll, and com.dll to the
path. any help would be great
Daniel
|