Years ago I tried but found trying to get it to compile too time
consuming for what it was worth. For use with cppBuilder, I think it is
much easier to compile the EPICS base with MSVC (went through without a
complaint) then import the resulting dll's as libraries (using impdef
and implib) for use with builder, that is what I do and have not had any
big problems. You could just use import the dll's ( I think the binaries
come with the distro) which would save you the hassle. Hope it helps,
-Russ
~~~~~~~~~~~~~~~~~~~~~~~~~~
Russ Berg
Control Systems
Canadian Light Source Inc.
www.cls.usask.ca
Ph: 306.657.3572
~~~~~~~~~~~~~~~~~~~~~~~~~~
-----Original Message-----
From: Ding Jianguo [mailto:[email protected]]
Sent: Tuesday, September 14, 2004 11:09 PM
To: [email protected]
Subject: compiler base using C++ Builder 6[Scanned]
HELLO, every one,
If anyone has any experience in compiling EPICS base with C++
Builder? I have tried Many times, but there are some errors as
following. I donnot know what's the wrong. If anyone can give me any
instruction?
"Installing generic include file /include/tsDefs.h"
c:\\Borland\\Bcc55\\bin/bcc32 -q -tWM -tWD -a8 -D_WIN32 -D_RTLDLL -c
-D__STDC__=0 -k- -H- -R- -O1 -v- -vi -w -g0 -w-8012 -w-8060 -w-8071
Error E2266: No file names given
gmake[3]: *** [bucketLib.obj] Error 1
gmake[3]: Leaving directory `G:/base3145/src/libCom/O.win32-x86-borland'
gmake[2]: *** [install.win32-x86-borland] Error 2
gmake[2]: Leaving directory `G:/base3145/src/libCom'
gmake[1]: *** [libCom.install] Error 2
gmake[1]: Leaving directory `G:/base3145/src'
gmake: *** [src.install] Error 2
regards,
Jianguo DING
SSRF,Shanghai Institute of Applied physics
P.O Box 800204, Shanghai 201800
eMail: [email protected] <mailto:[email protected]>