Re:

[Graham Waters <Graham.Waters@triumf.ca>]

You might like to consider switching to the TMPC810 this is also a two
channel CAN bus controller based on the Philips SJA1000.
This same chip is used on the TIP810 for which EPICS support exists.
All I did was replace the Industry Pack layer with a pci layer and leave
the rest of the EPICS source code intact (well almost).

If you plan to use it on an Intel x86 VxWorks system a small 
modification needs to be made to the BSP. A MMU mapping entry for
the TPMC810 or TMPC816 must be made prior to MMU initialization.

If anyone would like the source code please ask.

Graham

J. Frederick Bartlett wrote:

>   Has anyone developed device and (I presume) driver support for the TEWS
> TPMC816 Extended CANBUS PMC module? Is anyone interested or considering this
> device?
>
> 											Fritz

--
+---------------------------------------------------------------------+
|Graham Waters, Control System Eng    phone: (604)-222-1047 ext 6531  |
|TRIUMF --- University of B.C,        Fax: (604)-222-7307             |
|Vancouver, BC, Canada                e-mail: Graham.Waters@triumf.ca |
|                                                                     |
|http://isacwserv.triumf.ca/edevel/homepage/graham01.html 
     |
+---------------------------------------------------------------------+