1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Re: IK320 problem |
From: | Juraj Krempasky <[email protected]> |
To: | "Shepherd, EL \(Emma\)" <[email protected]> |
Cc: | [email protected] |
Date: | Mon, 11 Jun 2007 14:55:04 +0200 |
Hi everyone,
I'm having problems with the IK320 support I am using for some Heidenhain encoders. When I try to change their direction or put them into homing/reference mode, the record goes into error state and I get messages like the following on the IOC console:
=============================================================== BL06I-MO-IOC-02 -> filename="../devIK320.c" line number=797 ik320WriteMbboSync() entering...
filename="../devIK320.c" line number=820 ik320WriteMbboSync() sending request (synchronous) failed...
status = (1033,10) not in symbol table PV: BL06I-OP-PGM-01:MIR:ENC1:DIR ik320WriteMbboSync()
status = 409000a ===============================================================
P.S. are you using the IK320 support from my PGM tarball?
-- _____ Swiss Light Source/ / [email protected] _/_/_/ _/ _/_/_/ /____ GFA - SLS _/ _/ _/ /Paul Scherrer Institute _/_/ _/ _/_/ ____/CH-5232 Villigen-PSI _/_/ _/ / Tel: ++41 56 310 5131 _/_/_/_/_/_/_/ _/_/_/___/ Fax: ++41 56 310 3151