Re: MVME6100 or 7100

["Ernest L. Williams Jr." <ernesto@slac.stanford.edu>]

Hi,

I have used the MVME6100 with both vxWorks 5.5.1 and also vxWorks 6.6 
with no problems.


By the way WindRiver does indeed supply a BSP for the MVME7100 under 
vxWorks 5.5.1 as well as vxWorks 6.6.



Thanks,
Ernest


Kate Feng wrote:
> Hi Matt,
>
> What is your application for the mvme6100 ?
> At NSLS, I developed the "disco" BSP for RTEMS 4.8, which was
> derived from the RTEMS-mvme5500 BSP to support the "discovery"
> based boards such as the mvme5500 and mvme6100.  The BSP
> works fine except the mvme6100 is not powerful enough to handle
> the fast data rate of one of my applications.
> I got impression from other users that the performance on the
> vxWorks/mvme6100 is similar to that on RTEMS/mvme6100.  Thus,
> I needed to choose a modern and cost-effective solution instead.
>
> Hope this helps.   Kate
>
> Matt Rippa wrote:
> > > Matt Rippa wrote:
> > > > Hi All -
> > > >
> > > > Are any sites using the MVME6100 on VxWorks 5.5.2/Tornado 2.2.1? If 
> > > > so, would you recommend these?
> > > >
> > > > Has anyone considered the new MVME7100 board? I'm not sure on the 
> > > > state of the BSP.
> > > >
> > > > Thanks,
> > > > -Matt