RE: Ipac with VIPC616

["Mark Rivers" <rivers@cars.uchicago.edu>]

You are telling it that your VIPC616 is set up for A16 address 0x0000.
Is this correct?  I've always put my cards at higher addresses than
this.

Mark


-----Original Message-----
From: tech-talk-bounces@aps.anl.gov
[mailto:tech-talk-bounces@aps.anl.gov] On Behalf Of wmoore@jlab.org
Sent: Wednesday, January 20, 2010 10:54 AM
To: tech-talk@aps.anl.gov
Subject: Ipac with VIPC616

Hey All,

I'm trying to setup a SBS VIPC616 with one IP-OCTAL-232 IP-pack.  The
jumper settings on the carrier have been checked and are correct.  After
issuing ipacAddVIPC616, the module is still not found.  Here's what I
see
on the IOC:

vxwrks@iocfel7 -> ipacAddVIPC616("0x0000,0x0A000000")
value = 0 = 0x0
vxwrks@iocfel7 -> ipacReport(2)
    IP Carrier  0: SBS/GreenSpring VIPC616, 4 slots
      C0 S0 : No Module
        ID = 0xfbff0080, I/O = 0xfbff0000, Mem = 0x12000000
      C0 S1 : No Module
        ID = 0xfbff0180, I/O = 0xfbff0100, Mem = 0x12800000
      C0 S2 : No Module
        ID = 0xfbff0280, I/O = 0xfbff0200, Mem = 0x13000000
      C0 S3 : No Module
        ID = 0xfbff0380, I/O = 0xfbff0300, Mem = 0x13800000
value = 0 = 0x0

I've tried this with Ipac and Asyn version already installed here at
Jlab
and have setup my own using ipac-2.8 and asyn-4.11.  Any ideas on why
the
module is not being initialized?

Wesley