EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  <20112012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  <20112012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: dynamic monitoring
From: Patrick Thomas <[email protected]>
To: [email protected]
Date: Fri, 21 Jan 2011 17:00:51 -0800
Hi,

I was wondering what the best way is to dynamically monitor channels in C. That is to start and stop monitoring channels at run time. I currently have a program that connects to and attaches monitors to a predefined list of channels and then goes into a ca_pend_event(0), which blocks forever. Should I change this to a loop and specify a certain time period, i.e. ca_pend_event(1) and add or remove channels in that loop?

Thank you for your time,
Patrick

Replies:
RE: dynamic monitoring Jeff Hill

Navigate by Date:
Prev: support for Tescom pressure controller Pierrick Hanlet
Next: RE: dynamic monitoring Jeff Hill
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  <20112012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: support for Tescom pressure controller Pierrick Hanlet
Next: RE: dynamic monitoring Jeff Hill
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  <20112012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024