EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  <20112012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  <20112012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: WAGO 750 Stepper/DC-Drive Controller with EPICS?
From: "Heiniger Martin" <[email protected]>
To: <[email protected]>
Date: Fri, 13 May 2011 11:52:08 +0200
Hello all,

Has somebody used a WAGO 750 Stepper Controller or DC-Drive Controller
together with EPICS?
Any information or an example is very welcome! Thank you.

(Here a list of the available HW:
http://www.wago.com/wagoweb/documentation/navigate/nm0dz__e.htm#stepper)

Best regards,
Martin
 
=========================================
Martin Heiniger
Common Applications
Control System SwissFEL
Paul Scherrer Institut (PSI)
WBGB/002
CH-5232 Villigen PSI
SWITZERLAND

Telefon: +41 (0)56 310 54 89
E-Mail: [email protected]
Internet: www.psi.ch
=========================================
 
 


Navigate by Date:
Prev: Re: Handling failures in st.cmd Till Straumann
Next: Positions Available at SLAC in Controls Leadership Shoaee, Hamid
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  <20112012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: Re: Handling failures in st.cmd Andrew Johnson
Next: Positions Available at SLAC in Controls Leadership Shoaee, Hamid
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  <20112012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024