EPICS Re: PMAC

Experimental Physics and Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 <2013> 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 <2013> 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025
<== Date ==>		<== Thread ==>

Subject:	Re: PMAC
From:	Andreas Balzer <[email protected]>
To:	<[email protected]>
Date:	Mon, 25 Mar 2013 13:49:06 +0100

Did you check the motor safety i-variables (I211..I214)?

Andreas

On 25.03.2013 13:23, Gaudiello, Phillip wrote:

We run the pmac on our Bryant grinders. We are having a problem and do not know how to fix it. We keep getting X Axis Software Limit faults. M211 keeps latching on. We can turn it off and as soon as we make the machine do a move the M211 latches back in and gives us the x axis software limit fault. Please send some advice.

Helmholtz-Zentrum Berlin für Materialien und Energie GmbH

Mitglied der Hermann von Helmholtz-Gemeinschaft Deutscher Forschungszentren e.V.

Aufsichtsrat: Vorsitzender Prof. Dr. Dr. h.c. mult. Joachim Treusch, stv. Vorsitzende Dr. Beatrix Vierkorn-Rudolph
Geschäftsführung: Prof. Dr. Anke Rita Kaysser-Pyzalla, Thomas Frederking

Sitz Berlin, AG Charlottenburg, 89 HRB 5583

Postadresse:
Hahn-Meitner-Platz 1
D-14109 Berlin

http://www.helmholtz-berlin.de

References:: PMAC Gaudiello, Phillip

Navigate by Date:: Prev: PMAC Gaudiello, Phillip; Next: [no subject] martin.wilson; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 <2013> 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025
Navigate by Thread:: Prev: PMAC Gaudiello, Phillip; Next: FW: PMAC austen.rose; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 <2013> 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025