1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 <2013> 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 <2013> 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | RE: genesys power supply IOC |
From: | Mark Rivers <[email protected]> |
To: | "'James F Ross'" <[email protected]> |
Cc: | EPICS Tech Talk <[email protected]> |
Date: | Mon, 22 Apr 2013 16:53:30 +0000 |
Does this speak an ASCII protocol? Do you know a valid command (you can probably figure it out from the stream protocol file). If so, you can just test by running telnet without the IOC: telnet
130.199.60.184 8003 See if it connects. Then you can type commands and see the response. Mark From: James F Ross [mailto:[email protected]]
I believe it uses TCP (it communicates via an ethernet connection). Below is my start up script. I got this IOC after it had been compiled on another machine, so it is quite possible I missed changing something.
I know the IP is right for the drvAsynIPPortConfigure, but I don't know if 8003 is correct. James On Mon, Apr 22, 2013 at 11:05 AM, Mark Rivers <[email protected]> wrote: Can you explain the interface to the power supply? It is serial, TCP, etc. Subject: genesys power supply IOC Hello all, |