EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <20132014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <20132014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: Using Wind River's ICE 2 On-Chip Debugger with EPICS
From: Ron Sluiter <[email protected]>
To: EPICS <[email protected]>
Date: Mon, 03 Jun 2013 09:26:02 -0500
Is anyone in the EPICS community using Wind River's ICE 2 On-Chip Debugger (OCD) with EPICS?

One of the limitations of the OCD/Workbench system is that it supports only one symbol file at a time. With our current method of building EPICS IOC's and loading them at run time (a DKM, in Wind River jargon), I am unable to load both OS kernel and EPICS symbols for source-code debugging.

Does anyone have experience (good or bad) with this?

Ron






Navigate by Date:
Prev: RE: EPICS cross compile with buildroot problems Hu, Yong
Next: RE: EPICS Archive appliance Emmanuel Mayssat
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <20132014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: Re: EPICS cross compile with buildroot problems Andrew Johnson
Next: SEQ with dynamic assignment of PV in array variable Emmanuel Mayssat
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <20132014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024