Experimental Physics and Industrial Control System
Hi Mark,
I have a comments and a question on this topic:
A) From my experience, there are three possible options to handle the
reconnect/reboot situation, that all have valid use cases:
1. DB is dominant, takes value from DOL or AutoSaveRestore, and writes
to the device.
2. DB is recessive, reads value from device.
3. DB is minimal invasive, takes value from DOL or AutoSaveRestore, and
does not interact with the device.
I am not sure how a single bit could encode these three options.
B) The PINI field menu currently has 6 options:
NO, YES, RUN, RUNNING, PAUSE, PAUSED.
What is the intended behavior for the four options that were not yet
mentioned in this thread?
Thanks,
~Ralph
- Replies:
- RE: EPICS device disconnects and reconnects Mark Rivers
- References:
- EPICS device disconnects and reconnects Mark Rivers
- Re: EPICS device disconnects and reconnects Kate Feng
- RE: EPICS device disconnects and reconnects Mark Rivers
- Re: EPICS device disconnects and reconnects Jason Abernathy
- Re: EPICS device disconnects and reconnects Kate Feng
- Re: EPICS device disconnects and reconnects Pearson, Matthew R.
- Navigate by Date:
- Prev:
Re: EPICS device disconnects and reconnects Pearson, Matthew R.
- Next:
RE: EPICS device disconnects and reconnects Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
<2013>
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: EPICS device disconnects and reconnects Pearson, Matthew R.
- Next:
RE: EPICS device disconnects and reconnects Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
<2013>
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024