Experimental Physics and Industrial Control System
Hi,
We plan to use a soft IOC and an OMS MAXnet motion controller to control a stepper motor. The soft IOC will communicate with the MAXnet motion controller's Ethernet interface. What are the existing EPICS device/driver supports that we can use for this soft IOC application? Can APS's Stepper/DC Motor Controller software or Mark Rivers' devMotorAsyn and drvMotorAsyn be used for this? What are the pros and cons comparing these two technologies? Are there other alternatives?
Advice is greatly appreciated. Thank you in advance.
William Lu
- Replies:
- Re: Device/Driver Support for Stepper Motor Control Ron Sluiter
- Navigate by Date:
- Prev:
Re: Trouble with OID name using devsnmp. John A. Priller
- Next:
Re: Device/Driver Support for Stepper Motor Control Ron Sluiter
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
<2014>
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Trouble with OID name using devsnmp. Nicoletta Petrella
- Next:
Re: Device/Driver Support for Stepper Motor Control Ron Sluiter
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
<2014>
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024