Dear Florian,
some years ago I did this implementation.
https://github.com/zumbruch/EPICS-DIM
Best regards,
Peter
Dr. Peter Zumbruch
EE - department / Controls group
E-Mail: [email protected]
Tel: +49-(6159)-71-1435 / Fax: +49-(6159)-71-2986
GSI Helmholtzzentrum für Schwerionenforschung GmbH
Planckstraße 1 / 64291 Darmstadt / www.gsi.de
Gesellschaft mit beschränkter Haftung
Sitz der Gesellschaft: Darmstadt
Handelsregister: Amtsgericht Darmstadt, HRB 1528
Geschäftsführung: Professor Dr. Dr. h.c. mult. Horst Stöcker, Ursula Weyrich
Vorsitzenderdes Aufsichtsrates: St Dr. Georg Schütte
Stellvertreter: Ministerialdirigent Dr. Rolf Bernhardt
-----Ursprüngliche Nachricht-----
Von: [email protected] [mailto:tech-talk-
[email protected]] Im Auftrag von Florian Feldbauer
Gesendet: Donnerstag, 26. Februar 2015 14:15
An: EPICS Tech Talk
Betreff: EPICS device support for DIM
Hey all,
you would like to use the DIM protocol
http://dim.web.cern.ch/dim/index.html
to communicate with our FPGAs of the front-end electronics of our detector.
These front-end boards also contain data belonging to the Detector Control
System handled by EPICS.
So we would need a device support for DIM. Does anyone has written
something in this direction already?
If not, is there some easy to follow documentation about writing I/O
interrupt handler for the device support?
I have programmed a few small device support routines already. But never
with I/O interrupt handling...
Best regards,
Florian
--
----------------------------------------
| Dr. Florian Feldbauer |
| |
| Helmholtz-Institut Mainz / |
| Johannes Gutenberg-Universität Mainz |
| Johann-Joachim-Becher-Weg 36 |
| D-55128 Mainz |
| |
| Office: SB1 / 00-321 |
| Phone: (+49)6131 / 39-29605 |
----------------------------------------