| 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 <2015> 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 <2015> 2016 2017 2018 2019 2020 2021 2022 2023 2024 2025 |
| <== Date ==> | <== Thread ==> |
|---|
| Subject: | RE: autosave ---Data coverage |
| From: | "Mooney, Tim M." <[email protected]> |
| To: | l123173 <[email protected]>, "[email protected]" <[email protected]> |
| Date: | Tue, 30 Jun 2015 15:22:31 +0000 |
|
Hi Li,
I think you want an archiver. You want not only the current value of a PV to be saved, but all values. You probably also want the times when the value changed. Yes? If so, autosave is not the tool you want. I haven't used or deployed an archiver, but others on this list are expert at it. There are several solutions. Tim Mooney ([email protected]) (630)252-5417
Software Services Group (www.aps.anl.gov) Advanced Photon Source, Argonne National Lab From: [email protected] [[email protected]] on behalf of l123173 [[email protected]]
Sent: Tuesday, June 30, 2015 9:59 AM To: [email protected] Subject: autosave ---Data coverage Hi everyone,
I have a little question about the autosave module. (RH 6.0, synApp5-6, autosave4-8) I started the xxx module and autosave module worked well, but the newest data would be covered, I want all number of the data(pv) be saved. I did not use the array, the data is just a numble. Could you give me some advice? Thank you, Li xing |