1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 <2017> 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 <2017> 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Re: IOC Connecting Problem |
From: | Pilkyu Jung <[email protected]> |
To: | Rod Nussbaumer <[email protected]> |
Cc: | [email protected] |
Date: | Wed, 22 Feb 2017 16:24:27 +0900 |
Rod: First of all, I appreciate your advice. It was very helpful. By the way, I have tried to use port 5024 and 5025. But, now IOC worked with port 5024, not port 5025. Can I ask you a question one more? When I use port 5024, the device worked with telnet automatically. Like a Image file(16:18:10) that I attached a image file. However, I guess it should more fast without connecting telnet. At least, when I connect other device, didn't connect telnet. and when I use port 5025, it doesn't work.So, Could you let me know how can I use this oscilloscope on IOC without telnet connecting like other devices?
best regards, Pilkyu On 02/16/2017 11:15 PM, Rod Nussbaumer wrote:
Pilkyu:In your telnet connection, you use port 5024, but in the asyn port connection, you are attempting to use port 5025. This is quite likely one cause of your problem.Rod Nussbaumer TRIUMF Vancouver, Canada On 02/15/2017 10:29 PM, Pilkyu Jung wrote:Hi all, First of all, I am trying to connect from a oscilloscope which name is Agilent Technologies DSO-X 3052A (500 MHz 4 GSa/s) to IOC. As you can see in the manual(http://literature.cdn.keysight.com/litweb/pdf/75019-97073.pdf ,http://www.keysight.com/upload/cmc_upload/All/3000_series_prog_guide.pdf),this oscilloscope support a few ways (e.g. the IO Library, Telnet Sockets, and using Browser Web Control) for sending SCPI. However, When I connect to IOC, I got a problem. Until now, I just connected only adjust IP address in st.cmd. Like this, drvAsynIPPortConfigure("P1",169.254.90.3:5025,0,0,0) When I connect by telnet, it is done successfully (please check the Screenshot...image file). I don't know why this device can't be connected to IOC in this case. Definitely I am done with this way before, but now I can't. Here is my question,1. Normally, when you connect from device to IOC, what kind of method use?2. In my case, How can I connect to IOC? Best Regards, Pilkyu Jung
Attachment:
Screenshot from 2017-02-22 16:18:10.png
Description: PNG image