Hi Abdalla,
How is that CA Gateway configured?
(Even when started without command line arguments, a Gateway usually needs
configuration.)
~Ralph
On Wed, Mar 28, 2018 at 1:48 PM, Abdalla Ahmad <[email protected]
<mailto:[email protected]>> wrote:
Hi____
__ __
We are running the gateway on a virtual server with 1 network interface,
this server can see all the different LANs (office, machine, beamlines,
etc.) through routing rules and access lists done by the IT group. When the
gateway is running, after a while entire IOCs gets disconnected. We are
running the gateway with no arguments but in the .bashrc file we are
defining EPICS_CA_ADDR_LIST having the IP address for the gateway to look at
(Not all IOCs). This behavior happened when having all IOCs or some of them
in the address list.____
__ __
I came upon this video from APS https://www.youtube.com/watch?v=Y5Ge89Y4d1E
<https://www.youtube.com/watch?v=Y5Ge89Y4d1E> In which, as I understood,
they have multiple gateways running on the server with each gateway connects
one network interfaces together to the other interfaces. So my questions
are:____
__1.__What is happening with our setup? Some CA loops happens at some point?____
__2.__Is having a network interface per VLAN optional or recommended?____
__ __
Best Regards,____
__ __
Abdalla Ahmad____
Control Engineer____
SESAME____
Allan, Jordan.____
Tel: (+962-5) 3511348 , ext. 265 <tel:+962%205%20351%201348>____
Fax: (+962-5) 3511423 <tel:+962%205%20351%201423>____
Mob: (+962-7)88183296 <tel:+962%207%208818%203296>____
www.sesame.org.jo <http://www.sesame.org.jo/>____
__ __