RE: driver support for Gamma Vacuum QPC 4

["ian.gillingham@diamond.ac.uk" <ian.gillingham@diamond.ac.uk>]

At Diamond, we are just about to start using the QPC on new systems, but we don’t have any EPICS support for it yet.  I was intending to start developing a support module within the next few weeks, based on the DigitelMPC (looks like a similar protocol). So I am interested to see where this thread goes.

 

Regards,

Ian

 

Ian Gillingham

Senior Electronic Systems Engineer

Diamond Light Source

DH G.11

Didcot

Oxfordshire

UK

OX11 0DE

 

Tel: +44 (0)1235 778129

 

From: tech-talk-bounces@aps.anl.gov <tech-talk-bounces@aps.anl.gov> On Behalf Of Jack
Sent: 10 April 2018 11:01
To: EPICS Tech Talk <tech-talk@aps.anl.gov>
Subject: driver support for Gamma Vacuum QPC 4

 

Does anyone use Gamma Vacuum QPC 4 vacuum pump controller ?

Thank you

-- 

  Mauro Giacchini

--

Mauro Giacchini Control System Specialist  ISTITUTO NAZIONALE DI FISICA NUCLEARE   p/f: 0039.049.80.68.558 a: Viale universita' 2, 35020 Legnaro, PD -ITALY-  e: mauro.giacchini@lnl.infn.it s: yakman000

 

 

---

Questa e-mail è stata controllata per individuare virus con Avast antivirus. www.avast.com

Attachment: smime.p7s
Description: S/MIME cryptographic signature