Dear All,
I have a device which can be communicated with via serial port but at a strange baudrate of 3062500. This value has been set by the manufacturer and cannot be changed. So, I created a simple IOC using StreamDevice to communicate with it. But when I run the IOC it gives me this:
drvAsynSerialPortConfigure("SERIALPORT","/dev/ttyUSB5",0,0,0)
asynSetOption("SERIALPORT",-1,"baud","3062500") setOption failed Unsupported data rate (3062500 baud)
So, the question is: is it possible to make StreamDevice work with such non-standard baudrate and how? If not, is there any way around it?
Thank you.
Konstantin
========================================
Dr. Konstantin Kruchinin
Researcher
ELI-Beamlines
Institute of Physics of the Czech Academy of Science
Fyzikální ústav AV ČR, v.v.i.
Za Radnicí 835
Dolní Břežany 252 41
========================================
