EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  <20192020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  <20192020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: procServ and core dumps
From: Abdalla Ahmad via Tech-talk <[email protected]>
To: "[email protected]" <[email protected]>
Date: Sun, 16 Jun 2019 08:23:03 +0000

Hi

 

When an IOC is running under procServ, is a core dump generated when the IOC receives a segmentation fault? Assuming “ulimit –c 100000000” is executed before invoking procServ. Will procServ run the IOC again?

 

Best Regards,

 

Abdalla Ahmad

Control Engineer

SESAME

Allan, Jordan.

Tel: (+962-5) 3511348 , ext. 265

Fax: (+962-5) 3511423

Mob: (+962-7)88183296

www.sesame.org.jo

 


Replies:
Re: procServ and core dumps Ralph Lange via Tech-talk

Navigate by Date:
Prev: A-82x PIglide Motion Controller Sobhani, Bayan via Tech-talk
Next: Re: procServ and core dumps Ralph Lange via Tech-talk
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  <20192020  2021  2022  2023  2024 
Navigate by Thread:
Prev: A-82x PIglide Motion Controller Sobhani, Bayan via Tech-talk
Next: Re: procServ and core dumps Ralph Lange via Tech-talk
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  <20192020  2021  2022  2023  2024