1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 <2020> 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 <2020> 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | RE: error in 'make' during installation of areaDetector |
From: | Mark Rivers via Tech-talk <tech-talk at aps.anl.gov> |
To: | 'Jong Woo Kim' <Jong.Woo.Kim at asu.edu> |
Cc: | tech-talk <tech-talk at aps.anl.gov> |
Date: | Wed, 26 Feb 2020 00:13:27 +0000 |
Hi Jong Woo, Ø
After modification of configure files, I ran 'make'. But the following message came out.
Did you modify the following files in areaDetector/configure: RELEASE_LIBS.local (to set paths to base, SUPPORT, asyn, etc.) RELEASE_PRODS.local (to set paths to base, SUPPORT, asyn, etc.)
CONFIG_SITE.local (to change build options) RELEASE.local (to control what gets built) What directory were you in when you typed “make”? You should be in the top-level areaDetector directory. Please send the complete output of “make” and your RELEASE_LIBS.local and RELEASE_PRODS.local files. Mark From: Tech-talk <tech-talk-bounces at aps.anl.gov>
On Behalf Of Jong Woo Kim via Tech-talk Hello,
Via 'git clone', I installed 'areaDetector' under [synApps_6_1/support], and 'ADCore', 'ADsupport' and 'ADEiger' below it.
After modification of configure files, I ran 'make'. But the following message came out.
_________________________________________________________ configure/CONFIG:17: /configure/CONFIG: No such file or directory configure/RULES_TOP:2: /configure/RULES_TOP: No such file or directory configure/RULES_TOP:2: /configure/RULES_TOP: No such file or directory make: *** No rule to make target `/configure/RULES_TOP'. Stop. _________________________________________________________ It would be appreciated, if you give me a feedback.
Best, Jong Woo |