Experimental Physics and Industrial Control System
Ditto on the wish list from BESSRC as well . . .
I'm been told that the NI-1014 board is supported, but the jumper settings
are not what the board comes as or used with NiDAQ type software. Someone
told me what the settings should be to run under EPICS but I could never
get the thing to recognize correctly.
Wonder if there is a book market for someone to write "EPICS for Idiots"?
Me
----------
> From: Ernest L. Williams Jr. <[email protected]>
>
> I am one of the APS beam line users responsible for beamline controls.
I am in the market for a nice GPIB
> RS232/RS485 VME-based solution running under EPICS only.
>
> For my application HIDEOS is too much overhead. I think HIDEOS is an
excellent system but its use, of course,
> is application dependent.
>
>
> Is anyone using the GPIB 1014 by National Instruments under EPICS?
>
- Navigate by Date:
- Prev:
Serial and GPIB IP's and IP Carriers Ernest L. Williams Jr.
- Next:
Re: Serial and GPIB IP's and IP Carriers S. Joshua Stein
- Index:
1994
1995
<1996>
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Serial and GPIB IP's and IP Carriers Ernest L. Williams Jr.
- Next:
Re: Serial and GPIB IP's and IP Carriers S. Joshua Stein
- Index:
1994
1995
<1996>
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024