Re: sequencer installation

[Janet Anderson <jba@aps.anl.gov>]

If a configure/RULES_BUILD file exists in a support module defined
in an application's RELEASE file it will be included by Makefiles
during the build. This allows a support module to create module
specific build rules to be used by ioc applications which use the
support module.

When a make is done in the configure directory of a makeBaseApp.pl
application a RULES_INCLUDE file is created in each O.<arch>
subdirectory. This file contains an include line for a RULES_BUILD
file from each support module defined in the configure/RELEASE file
(except EPICS_BASE). The created RULES_INCLUDE file will be included
by EPICS_BASE configure files during the build.

Janet

Eric Norum wrote:
> I'm sure that Janet can provide a better explanation of this, but the 
> sequencer seems to work fine for me without requiring any manual 
> additions to the RULES_BUILD file.  I have only to add a definition for 
> SNCSEQ in the configure/RELEASE file:
>
> SNCSEQ=/usr/local/iocapps/R3.14.8.2/modules/soft/seq/2-0-11-asd2
>
>
> On Oct 6, 2006, at 8:00 PM, Emmanuel Mayssat wrote:
>
> > Mark,
> >
> > I also need to include the RULES_BUILD file that comes with the
> > sequencer source to be able to build the C files from the st one. 
> >
> >
> > MyIoc_SRCS=sequencer.st
> >
> > include ${EPICS_SEQUENCER_TOP_DIR}/configure/RULES_BUILD
> >
> > --
> > Emmanuel
>
> --
> Eric Norum <norume@aps.anl.gov <mailto:norume@aps.anl.gov>>
> Advanced Photon Source
> Argonne National Laboratory
> (630) 252-4793