1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Re: Motor Record - OMS58 Driver |
From: | "Ronald L. Sluiter" <[email protected]> |
To: | Ralph Lange <[email protected]> |
Cc: | EPICS Tech Talk <[email protected]> |
Date: | Fri, 13 Apr 2007 09:39:49 -0500 |
If you look at the "Known Problems" from R5-4 to R5-9 on the motor record web page;
In other words, the 2nd argument was eliminated. That is probably your problem.1. An undocumented change was made in R5-4 to two OMS setup functions. Namely, the unused 2nd argument ("axes per card") was eliminated from omsSetup() and oms58Setup().
Hi -
I'm moving a stepper motor application using an OMS VME58 card: from EPICS 3.13.9 / motor 4.9.3 to EPICS 3.14.8.2 / motor 6.1
In the old setup everything works fine, in the new setup the driver claims that it doesn't find the VME58 motor card. Hardware settings are unchanged, the setup call in the st.cmd is the same.
Searching the release notes of the motor record I did not find anything that I found applicable to my problem.
Before I dig into the code: Is there anything obvious that I didn't see? Similar effects somewhere?
HW: vxWorks 5.4.2, mv2100, OMS VME58, test stand with no other VME cards.
Thanks a lot! Ralph