1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024 |
<== Date ==> | <== Thread ==> |
---|
Subject: | Firewire (IEEE1394) Camera driver - errors in st.cmd file |
From: | "Margaret Smith" <[email protected]> |
To: | <[email protected]> |
Date: | Thu, 19 Apr 2007 16:13:56 -0600 |
st.cmd -- Line 18 -- Command save_restoreSet_Debug not
found.
st.cmd -- Line 19 -- Command set_requestfile_path not found.
st.cmd
-- Line 20 -- Command set_savefile_path not found.
st.cmd -- Line 21 --
Command save_restoreSet_status_prefix not found.
st.cmd -- Line 22 -- Command
set_pass0_restoreFile not found.
st.cmd -- Line 23 -- Command
set_pass1_restoreFile not found.
st.cmd -- Line 29 -- Command
create_monitor_set not found.
I've also attached the entire st.cmd file and the output when I run (st.cmd.out1).
I've got an inkling of what they, but don't know where they are. I could just remove these but may miss a feature that I want.
Thx,
Margaret
Attachment:
st.cmd.out1
Description: st.cmd.out1
Attachment:
st.cmd
Description: st.cmd