Experimental Physics and Industrial Control System
At a remote site, I have a backup generator that I am monitoring through
an EPICS IOC. When the generator faults offline, it sends a numeric
fault to the IOC of what the particular error is.
I want to display a text error message instead of the fault number on
my edm display. The generator generates 1 of 235 errors. How do I
convert the error number into a text message, and return it through a ca
link? The error number I can easily return, but is there a way to build
a 'lookup table' in EPICS?
Also, is there a way to have the IOC send out an email alert when the
system faults? The site is around 50 miles from my office, but only
around 5 miles from our nearest service person. I would rather have the
system email the service person with errors like "Unit Overheat", or
"Unit Maintenance Preset" or other errors, rather than me have to look
up the error code and then figure out who to notify.
David
BEGIN:VCARD
VERSION:2.1
X-GWTYPE:USER
FN:David Dudley
TEL;WORK:880-3740
ORG:;MIS
TEL;PREF;FAX:880-3741
EMAIL;WORK;PREF;NGW:[email protected]
N:Dudley;David
END:VCARD
- Replies:
- Re: EPICS: Selecting a Text Error Message Ralph Lange
- Re: EPICS: Selecting a Text Error Message Bill Nolan
- Re: EPICS: Selecting a Text Error Message Carl Lionberger
- Re: EPICS: Selecting a Text Error Message Schoeneburg, Bernd
- Navigate by Date:
- Prev:
Re: sysAtReboot and epicsExit Andrew Johnson
- Next:
RE: Severity of I/O interrupt records Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
<2008>
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: sysAtReboot and epicsExit Andrew Johnson
- Next:
Re: EPICS: Selecting a Text Error Message Ralph Lange
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
<2008>
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024