Fw:Re:Re: caget always not found

[l123173 <l123173@163.com>]

Hi Ralph,

      The email I sent to you be send back again and again, so I sent it here.
      I use the CA command on the same host as the IOC and the same computer.
     The pv name was typed rightly, it is the same as in "dbl".
     The whole command is "caget RPS1" and RPS1 is my pv name.

     I have used the CA command sucefully in other computer, I puzzled why I failed here. And I did not change the set up about ADDR_LIST and so on.

Cheers,
Li x

At 2016-04-27 17:48:39, "Ralph Lange" <ralph.lange@gmx.de> wrote:

Hi Li,

These messages look like the pv name is indeed wrong.

If you do a "dbl" on your IOC - is the pv name that you want to reach really "${pv}"? That looks quite unusual.
Make sure you don't have spaces or illegal characters in the pv on the caget/cainfo command line.

Are you using the CA command line tools on the same host as the IOC, or on a different machine?

Cheers,
~Ralph

On 27/04/2016 10:24, l123173 wrote:

Hi all,
    I wonder why I failed and got message " Channel connect time out: ${pv} not found " or camonitor "*** Not connected (PV not found)", when I use caget, caput, camonitor.
    I added the path to environment and I can move the motor successfully with my ioc and the pv name isn't wront.
    Could you give some suggestion?

Thanks,
Li x